What is the difference between LVP and LVT?
LVP means luxury vinyl plank, usually a long board with a wood pattern. LVT means luxury vinyl tile. It can describe a tile-shaped piece or a manufacturer's broader vinyl range. The dimensions and photos show the format. See our introduction to LVT for examples.
How do I choose between wood-look and stone-look vinyl?
For a long hallway, lay a sample of wood-look vinyl in the direction you want the grain to run. In a kitchen or dining room, set a stone-look tile sample beside your countertop to see how the patterns work together. Check both in daylight and under your evening lights.
What is the difference between a 12 mil and a 20 mil wear layer?
These numbers measure the clear layer over the design. A 20 mil layer is thicker than a 12 mil layer. For a busy room, compare the manufacturer's traffic rating and warranty as well as this number. Prescott Akadia is one example of a 20 mil plank.
Can I use waterproof vinyl flooring in a bathroom?
Choose a product approved for the bathroom floor and follow its instructions for the tub edge, seams and perimeter. Water can still reach the subfloor around the edges. A shower floor or continuously wet area needs a system specifically approved for that exposure.
Can vinyl flooring go over an existing tile floor?
Some rigid-core products allow it when the tile is firmly bonded, flat and in good condition. Deep grout lines, loose tiles or uneven edges may need repair first. Check the product's flatness and grout-joint limits with your installer. Our LVT preparation guide covers the first checks.
Does vinyl plank flooring need separate underlayment?
Check whether the plank already has an attached pad. Dunite Oak comes with one. Add a separate cushion only if the installation instructions allow that combination. A slab moisture barrier is a different material and may still be required.
Is click-lock or glue-down vinyl better for my room?
With click-lock vinyl, adjoining boards lock together and usually float over a prepared subfloor. Glue-down vinyl bonds to the subfloor with a compatible adhesive. The subfloor, traffic and size of the installation all matter. Our click-lock vinyl flooring guide shows how the boards fit together.
What should I check before laying vinyl on a basement slab?
Check that the product is approved for below-grade use. Have the slab tested for moisture and checked for flatness using the manufacturer's limits. Resolve leaks or dampness before the new floor goes down, even when the plank itself is sold as waterproof.
Can indoor luxury vinyl flooring be used outdoors?
For an open patio or deck, choose a finish rated for outdoor exposure. A waterproof indoor plank can still have temperature and sunlight limits. For an enclosed sunroom, check the exact product's permitted temperature range. Browse outdoor flooring and pavers for open-air projects.
How much vinyl flooring should I order?
Measure each area in feet, multiply length by width and add the areas together. Add the cutting allowance agreed with your installer for the layout. Divide the total by the square feet per carton on your chosen product, then round up to a whole carton.
How should I clean a vinyl floor?
Sweep or vacuum with a hard-floor setting to lift loose grit. For spills, use a soft cloth or damp mop and the cleaner recommended for the finish. Check the care guide before using any steam cleaner, polish or abrasive pad.